Canon Ir Error Code List. Code Description. E Communication error ( with pedestal). E Communication error (with ASSIST). Free downloads Error Codes Canon iRPage 1 of 5 Error Codes Canon iR Download here the full version of service manual iR Code List. Thank you for purchasing the Canon iR/iR/iR Series Machine. This Manual describes the use of the List of Error Codes Without Messages.
|Published (Last):||8 September 2009|
|PDF File Size:||11.96 Mb|
|ePub File Size:||17.45 Mb|
|Price:||Free* [*Free Regsitration Required]|
The finisher controller PCB is faulty. Replace the DC controller.
Canon IR 3300 Error Code List
Cause The stapler motor M6 is faulty. E The communication between the copier and the finisher is disrupted and is not corrected for 5 sec or less. Main cause The fixing film unit is faulty. The card reader PCB is faulty. E A specific level cannot be attained for the signal during CCD gain correction at power-on.
In the course of sensor output automatic adjustment, the light-emitting voltage is set to 4. The image processing element of the main controller PCB has a fault.
Replace the finisher controller PCB. Main cause The LAN card is faulty. Waste toner case full detection mechanism Remove the waste toner case, and turn off and then on the main power if3300.
Thereafter, turn off and then on the power switch. The heater drive power supply is faulty. The main thermistor has an open circuit. Main cause The horizontal home position sensor is faulty.
The fax PCB is faulty. Replace the fixing motor. Archives December August July The delivery belt home position motor PI7 is faulty.
The sub thermistor detects about C or higher Causes: The main power supply PCB is faulty. Replace the scanning lamp. Fixing film unit Check the interval between pin 1 and pin 2 and between pin 3 and pin 4 of the connectors 4-pin of the thermistor for electrical continuity.
canon ir error code Questions & Answers (with Pictures) – Fixya
If E, replace the main controller PCB. E The aligning plate rear does not leave home position when the alignment motor rear is driven eeror 3 sec. Connector Is the connector of the fixing assembly connected?
Main cause The DA unit is faulty. E A fault is detected in the battery for the image memory. Main cause The horizontal registration home position sensor PI2P is faulty. Fixing film unit thermistor Check the interval between pin 1 and pin 2 and between pin 3 and pin 4 of the connectosr 4-pin of the thermistor for electrical continuity.
E The temperature of the fixing film is as follows: Cause The front alignment motor M3 is faulty.
Canon Ir 3300 Error Code List
The setting roller home position sensor is faulty. Cause The stack handling motor M2 is faulty. Main cause The feed motor M1 is faulty. Replace the fixing film unit.
Main cause The stapler home position sensor PI19 is faulty. Is the drive voltage of the heater supplied by the connector J8 of the main power supply PCB?
Sensor lever damage and interferenceSensor Is abnormal noise heard from the horizontal registration assembly in keeping with the motor rotation?
E The return roller does not reach home position when the delivery motor Ml has been driven as much as will move it to the return roller home position sensor S3. Execute the following in service mode: